Tech Tips: Car O Liner Measurements

developerAuto Body Tips, Classic Car Restoration, Gallery, Muscle Car Restoration, Tech Tips, Uncategorized, VideosMay 11, 20180 Comment

IMG_3716-resized

For this post, we are using the 69′ Cobra Jet build as our demonstration. This car had the whole back quarter panels replaced, and once on the dedicated jig (Car O Liner), we can make sure the whole car is exactly where it needs to be aligned.

The Car O Liner we used has a three-dimensional mechanical measuring system, the picture below is of unibody collision project. You will see later in the post, how we use it to build the muscle cars.

 


Tech Tips: Car O Liner Measurements

 

 

Remember: While welding, you want to make sure that you don’t move the car on the dedicated jig and that it is very important to make the measurements on the car correctly, or your doors, trunk lid, and wheels won’t fit right.

 

Below you will see a photo of the Mustang on the dedicate jig. 

car o liner and measurements mustang R code

Below is a photo of the Mustang on the dedicated jig. It is done being welded and assembled and is now ready for ePoxy Primer. 

car o liner and measurements on dedicated jig

 


 

We hope you enjoy our post and found it useful.

If you have any questions, Contact Us.

We’d love to help!

Leave a Reply

Your email address will not be published. Required fields are marked *

Latest Videos

Recent Posts

1972 Wasque Boat Restoration by Bud Gallup

June 26, 2018

1979 K5 Blazer (Jimmy) Restoration

June 26, 2018

Mustang FastBack Steel Body

1969 Mustang Front-End Rebuild

June 25, 2018

73 bronco restoration srat\\\

1973 Bronco Build – Finishing Stages

June 25, 2018

low-mileage 1968 convertible Camaro restoration

June 14, 2018

428 Cobra Jet Mustang

1969 Cobra Jet Mustang Assembly

May 25, 2018

Get a quote